Amplifier Stereo Receivers Home Audio Outdoor Amplificador Dual Channel Sound
- Condition : New
- Dispatch : 2 Days
- Brand : None
- ID# : 217042773
- Barcode : None
- Start : Mon 22 May 2023 12:18:18 (EDT)
- Close : Run Until Sold
- Remain : Run Until Sold
for 1 item(s)
editShipping Calculator
More Listings from This Seller view all
Seller's Description
DESCRIPTION
Power Amplifier
· Stereo Mode
v Respectively connect the left & right signal source with CH1 and CH2. The output terminals respectively connect with a speaker.
· Parallel Mode
v Respectively connect speaker with output terminal of each channel. The output volume of each channel is controlled by the volume knob at the front panel.
· Bridge Mode
v Connect the positive terminal of both channels to speakers. The output volume is controlled by CH1/CH3 volume knob at the front panel.
· LED display
· Thermal protection for overheat overload, short circuit, dc, soft start
· Ready situation, signal indication, clip indication
· Gain control channel 1, channel 2
· Balance XLR input CH1,CH2, input connection
Technical Specifications:
8 ohm stereo power | 1200Wx2 |
4 ohm stereo power | 1800Wx2 |
2 ohm stereo power | 2400Wx2 |
8 ohm bridge power | 3600W |
4 ohm bridge power | 4800W |
Frequency Response | 20Hz-20KHz±0.3dB |
THD+N | <0.05%@8Ω 1KHz |
S/N Ratio | >103dB |
Slew Ratio | 35V/μS |
Damping Factor | >800 |
Crosstalk | >70dB@8Ω 1KHz |
Input Sensitivity | 1.4V |
Input impedance(balance/unbalance) | 10KΩ/20KΩ |
Voltage gain(sensitivity:8ohm) | 38dB |
Output Circuitry | Class H |
Cooling | Air flow from front to rear |
Protection | Soft Start, Dc, Short Circuit, Over Load, Clip Limit, Over Heat, Progressive Volume |
Product Dimensions (W*H*D) | 515*485*133(3U) |
Packing Dimensions (W*H*D) | 665*590*203 |
G.W(±5KG) | 42KG |
Power cord | BS 1363 Standard AC110V/60HZ.±10% AC120V/60HZ.±10%
|
USP:
· High performance
· Three modes of operation for ease of installation according to the need of event.
· Best suitable for live stage/DJ/studio/auditorium/worship.
· Thermal protection for overheat overload, short circuit, dc, soft start
POWER AMPLIFIERS 5C-CA-4(2X350 WATT)
| 2Ω Stereo Power | 2x770W |
| 4Ω Stereo Power | 2x450W |
| 8Ω Stereo Power | 2x350W |
| Bridge Power | 1350W (4Ω), 900W (8Ω) |
| THD+N | <0.03% |
| Slew Ratio | 20V/μS |
| DA MPING Factor | 400 |
| S/N Ratio | >90dB |
| Input Sensitivity 14KG | 0.775V,1V,1.4V |
| Input Imped (bal/unbal) CA2 | 20KΩ/10KΩ |
| Protection 2x300W | Overheat, short circuits, DC limit, and soft start, Output Relay-Zero Current Switch, Intellectual Clip Limiter |
| Freq. Resp (+0/-0.31W/8Ω) | 20Hz-20KHz, -3dB@100KHz |
| Crosstalk | >70dB |
| Gross Weight | 15KG |
| Dimension(in cm) | 59*27.5*15 |
5C AMP 30W UTX DLX
30 Watts < 3 Microphones, 1 AUX & 1 USB Inputs
voltage: 220V
Features:
- 70 Micron Glass E-proxy Printed Circuit Board
- Three-way power source amplifier - AC mains, 12V & Dry Cell Operation
- Easily compatible with Mixers/CD/DVD/VCD/MP3/MP4 players, Power amplifiers together
Technical Specification :
| Power Source | AC:220-240V 50/60Hz DC:12V (Car battery), Dry Cell |
| Power Output | 40W Max, 30W RMS at 10% THD |
| Output regulation | >84dB@20Hz to 20kHz at Maximum output |
| Input/Sensitivities | 3xMIC 0.60mV/4.7kΩ, 1xAux 125mV/470kΩ |
| Tone Controls | BASS:- ±8db at 100Hz TREBLE: ±8db at 10kHz |
| Signal to Noise ratio | 60db |
| Line Output | 125mV/470Ω |
| Speaker output | 4Ω, 8Ω, 16Ω |
| Dimensions | (296x294x116)MM |
| Weight | 5.17Kg |
5C AMP 60W DLX (220V)
60 Watts < 3 Microphones, 1 AUX & 1 USB Inputs
Features :
- 3 Microphone inputs, 1 Aux Input & 1 USB Input
- FM mode enabled
- 70 Micron Glass E-proxy Printed Circuit Board
- Two-way power source amplifier - AC mains, 12V
- Easily compatible with Mixers/CD/DVD/VCD/MP3/MP4 players, Power amplifiers together
- 2 Pin Main Chord
- Fully functional remote control amplifier
Technical Specification :
| Power Source | AC: 220-240V 50/60Hz DC: 12V (Car battery) |
| Power Output | 92W Max, 68W RMS at 10% THD |
| Output regulation | ≤2db, no load to full load at 1kHz |
| Input/Sensitivities | 3xMIC 0.65mV/4.7kΩ, 1xAux 125mV/470kΩ |
| Tone Controls | BASS:- ±10db at 100Hz TREBLE: ±10db at 10kHz |
| Signal to Noise ratio | 60db |
| Line Output | Pre Amp 125mV/470Ω |
| Power Consumption | AC: 140VA, DC: 6 Amps |
| Speaker output | 4Ω, 8Ω, 100V |
| Dimensions | (355x135x284)MM |
| Frequency Response | 50 to 15000Hz ±3dB |
| Weight | 6.60Kg |
AMPLIFIER WITH USB AND RECORDING 300 WATT
USP :
- Recording function to record music on USB, flash drive and hard drive
- 3 Pin Main Chord in 2 yard with 6A plug
- Best-quality lead-free solder used for strong connection between joints
- Portable and ideal for use in remote places without electricity
- Array of LED is put on front for visual monitoring of output level
Technical Specifications:
Power Source | AC 220-240V 50/60Hz & 24 V DC Operation |
Power Output | 300W RMS at 10% THD, 375 W Max. |
Output regulation | >84dB@20Hz to 20kHz at maximum output |
Input/Sensitivities | 6xMic 0.65mV/4.7k , 2xAux 100mV/470 kΩ |
Frequency Response | 50-18,000Hz ±3dB |
Tone Controls | Bass: 10dB at 100Hz, Treble: -10dB at 10kHz |
Signal to Noise ratio | 60db |
Pre-Amp Output | 125mV/470Ω |
Speaker output | 4Ω , 8Ω , 70V & 100V |
Power Consumption | AC:644 VA, DC: 14 Amps (Average) |
Dimensions | (L450 x W360 x H160)MM |
Weight | 17.50 kg |
Listing Information
| Listing Type | Gallery Listing |
| Listing ID# | 217042773 |
| Start Time | Mon 22 May 2023 12:18:18 (EDT) |
| Close Time | Run Until Sold |
| Starting Bid | Fixed Price (no bidding) |
| Item Condition | New |
| Bids | 0 |
| Views | 87 |
| Dispatch Time | 2 Days |
| Quantity | 5 |
| Location | United States |
| Auto Extend | No |
Seller Recent Feedback
Returns Policy
Refund Type: Money back or replacement (buyer's choice)
Shipping Cost Paid by: Seller
Returns Within: 30 Days
